Requirements, Scope of Application, and Debugging for Enamel Water Tank Suppliers to Produce Enamel Water Tanks

The enamel water tank foundation produced by the enamel water tank supplier can be made of concrete strip beams or I-beams.

In the actual production process of enamel inner tanks, due to the use of various raw materials and different production processes, there will be many different defects in the production of enamel water tanks by enamel water tank suppliers. The following aspects have a significant impact on the production of enamel water tanks by enamel water tank suppliers:
Steel plate is a very important low material for enamel inner lining. The quality of the steel plate selected by the enamel water tank supplier should be selected based on the forming (deformation, welding, etc.), coating process, and requirements of the enamel products. The expansion coefficient of enamel is 32x10 negative seventh power. The carbon content of the plates selected by the enamel water tank supplier shall not exceed 0.08%. Manganese exists in steel, which increases the yield limit and strength limit of the steel, while reducing its elongation performance. Therefore, the higher the manganese content, the greater the required deformation force. For carbon steel, silicon and manganese are both residues of deoxidizers during smelting. Steel plates with a silicon content below 0.37% can generally be subjected to deep drawing processing, but beyond this value, even steel with low carbon content will become hard and brittle, making it unsuitable for deep drawing processing and affecting its adhesion performance. The presence of sulfides will greatly affect the microstructure of steel plates, promote the formation of striped structures, thereby reducing the plasticity and toughness of cost steel, that is, reducing the cost drawing performance, and causing bubbles and pores to appear in the ceramic layer. Phosphorus dissolved in ferrite can significantly reduce the plasticity of cost steel, while increasing its strength and hardness. The lower the phosphorus content of steel plates used for deep drawing, the better. (<0.06%). Titanium added to steel is very beneficial for enamel, as it can combine with various components in the enamel, thus increasing its density. When coating the inner liner of a water heater in one go (wet flow coating, wet spray coating, electrostatic powder coating), titanium steel is an ideal substrate. Aluminum containing steel can be continuously cast with minimal composition segregation and inclusions, good cold working ability, and aging resistance. However, its major disadvantage is that it is prone to fish scale explosion defects and reduces the cost of bonding strength after enamel firing. Therefore, the thickness of the board selected by the enamel water tank supplier should be as thick as possible to ensure that the inner tank has sufficient thickness. The enamel water tank supplier can only ensure the enamel quality of the inner tank and thus guarantee the service life of the inner tank by selecting good enamel plates.
The enamel water tanks produced by enamel water tank suppliers can be widely used in public buildings such as hotels, buildings, restaurants, scientific research and teaching buildings, offices, offices, troops, garden villas, residential communities, entertainment venues, as well as secondary water supply places such as medical and health care and food processing. It is more convenient to renovate or update the water storage tanks in old buildings.
The enamel water tank foundation produced by the enamel water tank supplier can be made of concrete strip beams or I-beams. The top of the water tank is equipped with breathable air filtration devices diagonally, and the specifications and quantities of the devices are determined by the manufacturer based on the size of the inlet.